Metal Pro Anti-corrosive Primer
Product DescriptionQuick-drying alkyd primer, which efficiently protects the substrate against corrosion. Due to its fine penetrating qualities into porous substrates it is very suitable for manually cleaned iron.
TreatmentThe substrate must be clean, dry and solid, free from dirt, grease and oil.
For maintenance clean off loose paint, oxide scales and rust until a clean,
solid substrate is obtained, using a scraper, a grinder or a steel brush
(ST 2 in compliance with ISO 8501). Apply Flügger Metal Pro Anti-corrosive
Primer onto the cleaned surface straight after cleaning has been performed.
Clean with Flügger Metal Pro Cleaner.
Remove fouling, if any, with Flügger Façade Anti-green. Use a high
pressure cleaner if necessary. After application of the cleaning agents, it
is important to rinse abundantly with clean water. Flat sand glossy or
Stir thoroughly before use. Apply 2 coats by paint brush or by airless
sprayer on the same day as cleaning has been performed.
Always use a paint brush to apply the first coat on manually cleaned
substrates to ensure best available adhesion.
Perform finishing treatment with a solvent-based or aqueous paint after
maximum 2 weeks, in order to optimize the protection. Apply 2 coats of primer
and 2 topcoats for the best result.
ApplicationFor exterior and interior application as anti-corrosive priming paint on
iron, steel and pre-lacquered metal sheets.
Nominal spreading rate (m2/l)
Not to be diluted
Cleaning of Tools etc.
Storage: Cool and tightly closed